Tessco Wireless Journal January February 2017 Page 15 TESSCO Wireless Journal January/February 2017

wirelessjournal.tessco.com 15 4.3-10 connectors and adapters See full line of products at www.tessco.com/go/rfi 4.3-10 interface Low PIM Adapters Interconnect Solutions 8 Models of Intra-Series Adapters Adapters 4.3-10 to 7-16 DIN and N Low PIM "d-160 dBC Durable Non-Tranish Tri-Metal Plating New Modular Power Series The new ICT Modular Power Series is a flexible, hot-swappable DC power system for high power and redundant N+1 applications including base station infrastructure, fixed wireless broadband, small cell, radio access networks and DAS. The ICT Modular Power Series provides up to 150A of high efficiency power with 48, 24 and 12 volt output available. Available single or dual battery disconnects and four-position load distribution modules provide extreme flexibility for user requirements. The available Intelligent Control Module provides ethernet communications for remote monitoring and control of the system, including the ability to monitor current on each load output and power-cycle the four 20 amp outputs on the optional Load Distribution Module. When combined with the optional Battery Management Module, the Intelligent Control Module provides advanced battery functions including battery state of charge, temperature compensation, estimated run time remaining, and battery discharge testing, along with advanced low voltage disconnect features. The Intelligent Control Module provides an integrated, intuitive user interface, and SNMP is supported. Alarms can be sent to multiple email accounts. Four site monitoring inputs are available for sensor monitoring and reporting using the onboard interface. A second slaved power shelf can be added, providing up to 5600 watts of power for higher power requirements. Visit www.tessco.com/go/ict. Modular Power System for 48VDC, 1RU Redundant Hot Swap TESSCO No. 588274 List: $1,630.00 Power Module, 48VDC, 700W Output, Hot Swappable, Floating Output TESSCO No. 546726 List: $135.00 *Also available in other configurations. Consult ICT for details. Protect Your Investment in Vehicles, Equipment and People Havis's ChargeGuard is an easy-to-install, auto shut-off timer designed to safeguard expensive communications devices and computers with intelligent circuitry protection. ChargeGuard works by automatically turn- ing mobile equipment on when you start the engine. When you turn the engine off, the equipment stays on for an adjustable period of time and then is automatically disabled. When properly deployed, you can ensure that you'll never have another dead battery, at a very affordable price- cheaper than a single tow. ChargeGuard features easy installation, easy-to-set switches, choice of sensing modules, voltage diagnostic LED, and reverse polarity protection. ChargeGuard delivers higher productivity as it reduces downtimes caused by vehicle service calls. Since equipment is on when you want it, you can leave it unattended without worry. Don't let dead batteries affect your budget. Let Havis protect your investment by helping to keep your vehicle running efficiently with our power management solution. With ChargeGuard Auto Shut-off Timer, equipment is always available, and you never have to remember to turn it on or off. Visit www.tessco.com/go/havis. Negative Ground Ignition Sensing Timer Switch, 12V TESSCO No. 315672 List: $99.00 ChargeGuard Ignition Sensing Timer Switch ICT Modular Power Series

Previous Page
Next Page